Electric fireplace heater i n s t r u c t i o n m a n u a l w913t-33bk ndf-qc913 attention: 1. Find a location for the fireplace heater that is protected from direct sunlight. 2. Do not plug the unit into the power outlet before you read all instructions..
2 s a f e t y i n s t r u c t i o n s important please note when you open the carton carefully check the unit and make sure there are no damages. If you have any problems with the unit, with how the various functions work or with hidden damages or missing parts please call 1-800-459-4409 (est) immed...
3 8) do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Arrange cord away from traffic area and where it will not be tripped over. 9) to disconnect fireplace, turn controls to off, then remove plug from outlet. 10) connect to properly grounded outlets ...
4 be used if a three-slot grounded receptacle is available. A 15 amp circuit is required to operate this heater. If the breaker trips when the heater is used then you may need to move the heater to another location or un- plug other appliances that are on the same circuit. If you require an extensio...
5 a s s e m b ly i n s t r u c t i o n s parts list: fireplace 1 a) mounting bracket 1 b) mounting screws 3 c) wall anchors 3 d) washers 3 e) plastic pads 3 tools required: level, electric drill, drill bits 5/16 in (8 mm), phillips screwdriver, hammer, safety goggles and gloves. Caution: the firepla...
6 fig. E operation after reading complete instructions, confirm all controls on fireplace are in the off posi- tion. Plug the fireplace into a 15amp/120volt outlet. If the cord does not reach, you may use an extension cord rated for a minimum of 1875 watts. Once the fireplace insert has been properl...
7 operation by the remote control plug in your electric fireplace and it will beep once, this means you have power and your remote is ready to operate your electric fireplace. : standby switch. Press this button once the unit become energized and you can select the following functions as desired. Pr...
8 cleaning to reduce the risk of fire, electric shock or damage to persons. The bulbs in your unit can become extremely hot. Allow at least 10 minutes between turning off the unit and removing the light bulbs to avoid the accidental burning of the skin. Risk of fire: do not exceed the recommended bu...
9 warranty every electric fireplace heater is tested be- fore it leaves the factory and it is guaranteed for one year. If the unit should fail to operate correctly within one year from the date of purchase, call customer service at 1-800- 459-4409 (est). We will, at our discretion ei- ther repair or...
12.
