Quality Craft NDF-QC913 Instruction Manual - page 8
8
cleaning to reduce the risk of fire, electric
shock or damage to persons. The bulbs in
your unit can become extremely hot. Allow
at least 10 minutes between turning off the
unit and removing the light bulbs to avoid
the accidental burning of the skin.
RISK OF FIRE:
DO NOT EXCEED THE
RECOMMENDED BULB
WATTAGE.
REPLACING THE
LIGHT BULBS
Step 1: Remove the 4 screws that hold the
glass window in place.
Step 2: Remove the screws from both
sides of the log-set bed.
Step 3: Remove the log set bed — you will
find the 2 x 40 Watt type B-10 bulbs.
Step 4: Loosen and remove burnt out
bulb(s) and replace with new
bulb(s).
Step 5: Set the log-set bed back into place
and re-attach the screws.
Step 6: Position glass window in place and
fasten with the 4 screws.
Step 7: Plug in the unit.
CLEANING
To clean unit first turn off controls on unit and
unplug the unit from power source. To clean
glass display panel; remove dust with clean
dry cloth or to remove finger prints and other
marks clean glass with clean damp cloth. Do
not use abrasive cleaners or spray liquids on
glass display panel surface. Metal and metal
painted parts should be cleaned with damp
cloth. Do not use
abrasive cleaners or spray liquids on
these surfaces.
C L E A N I N G / W A R R A N T Y