Quality Craft QCC-1000 Instruction Manual - page 4
4
I N S TA L L AT I O N / M A I N T E N A N C E / C L E A N I N g
Wall Mounting
1) drill the required holes in the
wall using the positioning screw
holes.
) Attach the bracket to the wall with
the screws.
3) Mount the heater to the bracket
and engage the corresponding
slots on the rear of the heater.
Removing the heater
from the bracket
1) Press and loosen all clips.
) Pull the heater to disengage
the clips from the bracket.
Electrical Wiring
Warning: The heater must be
installed by a certified electrician
and in accordance with the local and
national building codes.
Warning: In Quebec, the installation
of this product must be carried out
by a qualified electrician.
Warning: This convection heater
is to be used on a 40/08
(Cd1)
V AC
power supply and grounded outlets.
Maintenance
Warning: To reduce the risk of fire
or electric shock, always switch off
the unit and wait 10 minutes to
allow it to cool before attempting
any maintenance or cleaning. It is
recommended that the heater is
cleaned periodically, in order to avoid
dust blocking the grill or ventilation.
Cleaning
Wipe the unit with a soft, damp cloth.
do not use abrasive cleaners or
spray liquids on the unit surfaces.
Note: It is possible that the unit
surface may discolour (yellow) over
time, due to dust or cigarette smoke.
This is normal and not a manufac-
turing defect.
"LACK,
4HERMALCUTOFF
PROTECTION
7HITE.
'REEN9ELLOW'