Quantum FC310 Quick Reference Manual - page 3
STEP 3:
CONNECT SCSI CABLES
a.
Attach a SCSI cable from the upper SCSI port on the library SCSI
controller to the first SCSI connector on drive 0. Terminate the
second SCSI connector on drive 0.
b.
Attach a SCSI cable from SCSI port 0 on the FC310 (the left VHDCI
connector) to the lower SCSI port on the library SCSI controller.
c.
If the library has two drives, attach a SCSI cable from SCSI port 1 on
the FC310 (the right VHDCI connector) to the first SCSI connector on
drive 1. Terminate the second SCSI connector on drive 1.
STEP 4:
CONNECT THE FIBRE CHANNEL CABLE
a.
Connect one end of the Fibre Channel cable to the Fibre Channel
port on the FC310.
b.
Connect the other end of the Fibre Channel cable to the Fibre
Channel port on an HBA installed in a host computer, or to a switch or
hub.
STEP 5:
STARTING UP/SELF-TESTING THE FC310
a.
Using the serial cable provided, establish a connection between the
serial (RJ45) connector on the FC310 and the COM port (DB9) of the
external host computer.
b.
Reconnect the library’s power cord to a grounded power outlet and
then turn on the library.
c.
When the library has powered up, turn on the host computer.
d.
Make sure the COM port on the host computer has the following
settings:
--
Baud rate: 9600
--
Data bits: 8
--
Parity: None
--
Stop bits: 1
--
Flow control: None
e.
Run HyperTerminal or equivalent.
SCSI cable
(FC310 to
drive 1)
Terminators
Terminator
FC310 SCSI Cabling—Two-Drive Library
Drive 1
Drive 0
C310 SCSI Cabling—One-Drive Library
SCSI cable
(FC310 to
controller)
SCSI cable
(controller
to drive 0)
Drive 0
SCSI port 0
SCSI port 0
SCSI
port 1