Quantum FC310 Quick Reference Manual - page 4
Copyright 2001 ATL Products, Inc. All rights reserved. Prism is a trademark of ATL Products, Inc. in the United States and other countries. Adobe and Acrobat are trademarks of
Adobe Systems Incorporated, which may be registered in certain jurisdictions. All other trademarks are the property of their respective companies. Quantum|ATL is the generally
known alternative designation of ATL Products, Inc. Specifications are subject to change without notice.
6473010v1r0
6207947-04sN 02
C
ORPORATE
H
EADQUARTERS
141 Innovation Drive
Irvine, CA 92612-3040
USA
Telephone: (949) 856-7800
Fax: (949) 856-7799
www.QuantumATL.com
E
UROPEAN
H
EADQUARTERS
7 Lindenwood
Chineham Business Park
Basingstoke, RG24 BWD
United Kingdom
Telephone: +44 1256 818300
Fax: +44 1256 848700
A
SIA
P
ACIFIC
H
EADQUARTERS
1st Floor Honda House
I80 Kingsford Smith Drive
Albion, Old 4010
Brisbane, Australia
Telephone: +61 7 3862 4655
Fax: +61 7 3862 4677
Quantum|ATL maintains offices throughout the
USA, Europe, and Asia
f.
At the
Ready
prompt, type firmwarerestart and press . This causes the firmware to restart and the power-on self-
test (POST) to run. During POST, make sure that all SCSI port initiator IDs are present and all status messages appear
normal.
The
Ready
prompt reappears when POST is completed.
STEP 6:
CONFIGURE THE FC310
A command-line interface (CLI) is available to assist with FC310 configuration and maintenance as well as system diagnostics.
Specifically, the CLI can be used to configure the serial, Fibre Channel, and SCSI ports; to create device maps; to obtain FC310
status information; to log FC310 events; and to report SCSI and Fibre Channel device information.
For more information, refer to the Quantum|ATL FC310 Bridge User’s Manual (PN 6421018).
NOTE: If POST messages do not appear, check all connections and COM port settings. Power cycle the library and
verify that the green “Ready” LED above the Fibre Channel port is on steady. Then repeat the startup procedure.