Quantum FC420 User Manual - page 20
Prism FC420 Bridge Option User’s Guide
Document 6473031-04, Ver. 4, Rel. 0
September 2003
20
Prism FC420 Services Software Commands
FcWWName
Sets/displays the current World Wide
Name (WWN) of the Fibre Channel
interface referenced. Each Fibre port has
a unique WWN. The least significant 6
bits of the WWN are used as the
Ethernet MAC address.
The
set
variant of the command allows
the user to change the last three bytes of
each WWN. Please note, however, that
the most significant bit of the three bytes
must be 1 in order to provide WWN
verification. Also note that the last bit of
each WWN may only be assigned one of
the following values: 0, 4, 8, or C for port
0; 1, 5, 9, or D for port 1; and 2, 6, A, or E
for port 2.
Fabric and loop operation is
unpredictable if duplicate WWNs are
used.
10 00 0x
,
where
x
is the
Fibre
port
number.
set fcwwname [portnumber
[0xnn 0xnn 0xnn]]
get fcwwname [portnumber]
FibreBridgeModel
Reports the specific FC420 model
information.
get fibrebridgemodel
FibreBridgeName
Specify the 8-character name assigned to
the FC420 bridge.
set fibrebridgename [value]
get fibrebridgename
FibreBridgeTargetLUN
Specify the soft target LUN used by the
FC420 when addressed by the host. This
LUN is taken from NVRAM.
disabled
set FibreBridgeTargetLUN [fp]
[fl] | [disabled] ]
FirmwareRestart
(Immediate)
Reboots the FC420 firmware.
firmwarerestart
Help
(Immediate)
Displays a list of available commands.
When the optional command name is
present, detailed command-specific
information is displayed.
help [command name]
IdentifyFibreBridge
Causes the Ready LED on the FC420
board to blink continuously until
disabled.
disabled
set identifyfibrebridge [enabled
| disabled]
get identifyfibrebridge
Info
(Immediate)
Displays version numbers and other
product information for key
components within the FC420.
info
IPAddress
Sets/displays the current IP address of
the FC420 bridge. If the
ipdhcp
command
is enabled, the get command reports the
current IP address assigned by the
nameserver.
10.0.0.1
set ipaddress xxx.xxx.xxx.xxx
get ipaddress
Command
Description
Default
Syntax