Quartet 23700 User Manual - page 14
13
Computer and pen communication
1
Insert the plug and play USB receiver into a free USB port on the
computer.
The USB receiver status light will flash red, blue then green. The Quartet
Kapture
ª software installer will automatically start. If it does not auto-
run, start the application manually by navigating to it via Windows
explorer or Mac OS finder.
The LED light will be red until the software is launched, upon which it
will turn blue.
Follow the on-screen instructions to install the Quartet Kapture
ª
software.
Confirm there is a battery installed in the pen.
2
Start up the installed Quartet Kapture
ª software ( ) and select
capture mode (
) followed by pen management mode (
).
Touch the pen (with or without the cap) to the middle of the setup card,
hold it there until the LED turns solid green.
Press and release the button on the USB receiver.
Lift the pen, the light will flash green, it will return to solid green when
paired to the system.
3
The pen will appear in the pen status area of pen management mode.
The pen is now paired to the system.
Set the pen color
4
Touch the pen to the color area on the setup card that matches the color
of the installed ink cartridge. The color shown in the pen management
mode/color area will change to the selected color. The pen is now ready
to use.
Note:
Once the pen is paired it will remain paired to that USB receiver. Pens
can be deleted through the software. Additional pens must be paired
in the same way as the first. Pairing is unaffected by loss of power or
changing the pen's battery.
The USB receiver must remain in the USB port while capturing.
Setup / initial system setup
1
2
3
4