Quest Engineering Flying ModelRocket KitL Assembly Instructions Manual - Mlas
Mask Orange
Shoulder Ring
Mask Orange
Shoulder Ring
Mask Orange
Shoulder Ring
Mask Orange
Shoulder Ring
MLAS
MLAS
Flying Model
Rocket Kit
Step 21
A. Using masking tape, mask out the black areas
shown here. Also mask the Orange Capsule
Shoulder Ring to prevent any paint from getting on it.
B. Paint the black areas with
Foam Safe Gloss Black Spray
Paint.
F. After the paint has dried, remove the Capsule Assembly by
gently twisting and pulling it out or it might remain stuck.
Step 19
A. Slip the Capsule Assembly into the Main Body Tube. DO NOT GLUE!
D. Once again, slip the Capsule Assembly into the Main
Body Tube. DO NOT GLUE! Twist it a few times to ensure
the fit is not too tight.
B. Paint the entire rocket with Foam Safe Primer. Follow
instructions on the spray can for best results.
B.
E.
C. After the primer has dried, remove the Capsule Assembly
by gently twisting and pulling it out or it might remain stuck.
E. Paint the entire rocket with Foam Safe Gloss White.
Follow instructions on the spray can for best results.
PAGE07
Step 20
A. After the Foam Safe Gloss White has completely
dried, cover the Body Tube with paper or a plastic
bag, with the fins completely exposed. Use Masking
Tape to secure the cover to be even with the root of
the fins. Leave the bottom open so it gets painted
as well, but cover the top so no paint gets inside.
B. Insert a rolled up newspaper in the Motor
Tube to hold the rocket with while painting.
Paint the exposed areas of the rocket with
Foam Safe Gloss Black. Follow instructions
on the spray can for best results.
Insert a rolled up
newspaper in the
Motor Tube
C. After the paint has dried, remove the
Masking tape and paper.