Quest Engineering Flying ModelRocket KitL Assembly Instructions Manual - Step 23
Step 23
Step 24
A. Tie one end of the thin Kevlar
cord around the Nose Bolt.
A. Tie a 2" loop in the end
of White Shock Cord.
A.
B. Tie a 2"
loop in the
other end of
the thin
Kelvar cord.
C. Pass the
Shroud Line
loops of one of
parachutes
through the loop
in the Kevlar and
pull them
straight.
B. Pass the
Shroud Line
loops of the third
parachute
through the loop
in the White
Shock Cord and
pull them straight.
D. Repeat
Step "C"
for second
parachute.
MLAS
MLAS
Flying Model
Rocket Kit
Step 22
A. Remove the Gripper
Shroud Line Fasteners from
the strip one at a time.
Always handle Grippers by
the edge so that you don't
touch the adhesive. Place
each Gripper on one of the
six corners of the parachute.
A.
B.
C.
B. Firmly squeeze
each Gripper and
parachute material
between your fingers.
C. The Shroud Line is pre-cut
into three equal lengths. Take
one length of the Shroud Line,
pass it through the hole in the
Gripper and tie one end with two
overhand knots. Tie the other
end of the shroud line to the
nearest Gripper. Repeat for
remaining Shroud Lines.
PAGE08
B.
3014-1010B