Summary of QSR1000
Page 1
Am/fm stereo receiver instructional manual qsr1000
Page 2: Federal Communica
Federal communica tions commission (fcc) information 2 this device generates and uses radio frequency (rf) energy, and if not installed and used properly, this equipment may cause interference to radio and television reception. If this equipment does cause interference to radio or television recepti...
Page 3: First Thing First
3 first thing first unpack the receiver..........................................................................................................4 basic connections.......................................................................................................................4 system setup......
Page 4: First Things First
First things first 4 basic connections assuming you have a vcr, the following steps will help you quickly set up your new receiver. If you have more electronic components, consult the table of contents or index for the page on which to find the connection description that best suits your situation. ...
Page 5: First Things First
First things first 5 connecting the antennas the am and fm antennas connect to the am and fm ter minals on the system's back panel.They must be hooked up for you to receive clear reception. Uncoil the antenna wires and locate the bare ends. Press down on the tab to open the terminal and insert the w...
Page 6: First Things First
First things first 6 using headphones t o listen privately through your audio system, use the phones jack to the right of the volume dial on the receiver. Note: headphones are not included. Connecting for power make sure you connect all your other electronic components and your speakers before plugg...
Page 7: Receiver Controls & Opera
Receiver controls & opera tions 7 general controls power st and by/on the power st andby/on button activates or deactivates the system. When the system is activat- ed, the unit will default to the last mode it was in before power was removed. Tuning down/up the tuning down/up buttons allow you to sc...
Page 8: Receiver Controls & Opera
Receiver controls & opera tions 8 tuning the receiver display messages the following is an example of all the display messages you may encounter while using your receiver . Specific messages are referenced within the section(s) they apply. Select the am/fm band 1. Push the fm or am button on the rec...
Page 9: Receiver Controls & Opera
Receiver controls & opera tions 9 to store a st ation 1. Press the fm or am button on the receiver (or the am-fm button on the remote). 2. Select the station you want to store in memory using the methods described above. 3. Press the memory button on the remote until "memory" blinks in the display. ...
Page 10: Connecting Auxilar
Connecting auxilar y components 10 before you connect .. Connecting the cables • protect components from power surges. • connect all components before plugging power cords into the wall outiet. • always turns off the receiver and/or components before you connect or disconnect any cables. • always ma...
Page 11: Connecting Auxilar
Connecting auxilar y components 11 connecting a t ape deck using two paired (red/white) stereo cables, connect your new receiver to your tape deck as shown in the diagram to the right. To play a tape, press tape and then play. To record a tape, turn on the audio source you want to record from and th...
Page 12: Using The Remote Control
Using the remote control 12 ba ttery installation the remote control operates on two batteries. Install them before attempting to operate the remote. 1. Slide the battery compartment cover off the back of the remote. 2. Insert 2 aaa batteries, matching the + and - ends of each battery with the symbo...
Page 13: Care and Maintenance
Care and maintenance 13 general no audio. • make sure the mute inclicator on the front panel is off. • make sure the speakers are turned on. • check the connections. • check the power cord connection. No audio from one channel. • adjust the balance control. • check the speaker wire connection or con...
Page 14: Equipment Specifica
Equipment specifica tions 14 amplifier section left & right channel: 100w atts 1% thd @ 1khz muting attenuation: 90 db frequency response: 80 - 10 khz +/- 3 db am tuner section frequency response: 8ohz - 2.3khz +/- 6 clb usable sensitiivity: 800 uv/m @: s/n 20 db signal to noise: 38 db image ratio: ...
Page 15: Limited W
Limited w arranty 15 quest warrants this product to be free from manufacturing defects in material and workmanship under normal use for a period of 1 year from date of purchase, if service is required during the first year of ownership, product should de returned to the store where it was purchased ...
Page 16: Impor
Impor tant safety instructions before using the product, please follow and adhere to all war nings, safety and operating instructions located on the product and in the user book. Save all instructions for future reference. Do not expose product to rain and do not use near water; such as, sink, wet b...