Quickie 2 User Instruction Manual & Warranty - page 7
B. ADJUSTABLE SEAT POSITIONING
1. Adjustment
a. While seated in the Shadow Mach 2,
with your right hand hold onto the
main frame tube (A).
b. With your left hand pull the seat
adjustment lever (B) outward.
c. Adjust the seat forward or rearward.
Note: Slide the seat forward so when your arms
are fully extended they still have a slight bend in
the elbows, about 10 degrees. Lower levels,T-8 or
less, may want the seat back a little so they can use
some body movement.
C. REAR WHEELS INSTALLATION
1. Threaded
a. Remove threaded axles, axle nuts and
washers from plastic bag.
b. Insert threaded axle (C) and washer
into frame (D) and tighten.
c. Slide rear axle wheel (E) onto thread-
ed axle.
d. Insert the axle nut (F) and tighten
until all play is removed.
e. Repeat on opposite side.
2. Quick-Release (Optional)
a. Depress the quick-release button (A)
on the axle.
b. Slide it into the axle sleeve (B) until
it locks.
An unlocked axle may come off during
use, resulting in a fall and severe injury
to you.
Never use the hand-cycle unless you
are sure the quick-release axles are
locked.
When locked, the outside quick-
release buttons will pop out to their
fully extended position.
12
V I I . S E T U P & A D J U S T M E N T
13
D. FOOTREST
1. Height-Adjustment
a. Remove bolts attaching the footrest
to the main frame tube.
b. Reposition footrest extension tube up
or down on main frame tube using
pre-drilled holes.
c. Replace bolts and retighten.
The lowest point of the footrest should
be at least 2 1/2" between the ground
and underside of the footrest.
2. Angle-Adjustment
a. Loosen flat socket head cap screws
located on top of footplate.
b. Rotate footplate to desired angle.
c. Retighten bolts.
d. Repeat on other side.
Note: Be careful to leave enough clearance to
turn the front wheel.
E. TOW BAR (Optional)
The Shadow Mach 2 wheelchair tow bar
has been designed to work with most
wheelchairs. Your front casters will be
held off the ground by two clips (A) sup-
porting the caster axles. Minimum clear-
ance for the tow bar to work between
caster fork and wheel is 1/8".
Important Note: Caster forks that extend too
far below wheel axle may interfere with the tow
bar clip. Read through all instructions before
mounting the tow bar to the Shadow Mach 2.
It will be necessary to make a few minor adjust-
ments to the tow bar to fit your wheelchair.
V I I . S E T U P & A D J U S T M E N T
s
!
W A R N I N G S
s
!
W A R N I N G S
B
A
F
E
C D
B
A