Quickie Attitude Owner's Manual - page 12
12
SUNRISE
smart MAN-MACHINE INTERFACE (sMMI)
If GPS is not activated on your phone, you will be prompted to
activate it. Confirm the GPS authorisation request. After a short
wait, a GPS signal is detected. If the GPS geolocation is not wor-
king, you should eliminate any factors that may be interfering with
it. For the geolocation, remove your phone from the case so that it
does not negatively affect GPS performance. Also, you should not be
in a building, as thick walls can strongly affect the GPS signal, and
your phone will not be able to establish a GPS connection. Also note
that in some areas this may take up to five minutes. Please be
patient.
Note: You can plan your tour even without GPS reception (by
entering a place as a starting point). The GPS connection must be
active when you start the navigation at the latest.
Destination: Please enter your destination in this order: street,
house number, place, such as Friedrichstrasse 19, Berlin. Other
input formats are also recognised to some extent.
Figure 27: Start navigation
Figure 28: Navigation view 1 on the
sMMI Connect
If you tap the “Plan route” button, you can see the calculated route.
Start the navigation by pressing the Play button on the bottom right.
Double-click the middle button of the remote control to copy the
routing information to the sMMI.
The smartphone can be stowed in your pocket.
Arrow navigation: Display of directional arrows and turning
instructions.
Map navigation: Display of a map section. By double-clicking the
top button of the remote control, you zoom in, and if you double-
click the bottom button, you zoom out.*
* Depending on the smartphone model, there may be differences in
the presentation options and presentation speed of the map
navigation.
Note regarding the smartphone‘s battery life: Transfer of the map
and routing information from the smartphone to the sMMI increases
the power consumption of the smartphone. We recommend
extension of the runtime using a power bank (spare battery). You
can of course use the navigation function when touring with all
other bicycles.
Figure 30: Three
zoom levels,
level 2 active
Figure 29:
Navigation view 2
on the sMMI Connect
MK-100383 Rev. A