Quickie QM-710 Owner's Manual - page 28
118444 Rev. D
28
Q M- 7 1 0 /7 1 5 H D / 7 2 0
I. SEAT DEPTH ADJUSTMENT
10" - 18", 12" - 20" only
The seat depth can be adjusted in one inch increments on standard rehab seating.
1. Seat Frame Depth Adjustment
a. To adjust, remove the two bolts (A & B) from each side of the backrest pivot plate.
b. Reposition the backrest to the desired position.
c. Replace and retighten bolts on each side of the backrest pivot plate.
2. Back Angle Adjustment on Seat Frame
a. Remove the front securing bolt (A) on the side of the backrest hinge plate.
b. Loosen the lower rear bolt (B)
c. Set at desired angle. There are five holes (in 4º increments) to choose from.
d. Reinstall the front bolt and tighten both bolts securely.
J. ASAP II SEATING ADJUSTMENT
Please refer to the ASAP Seating Adjustment Guide for details on how to adjust the seat
depth, seat width, armrest height and backrest angle.
Pre-tilt and Seat-to-floor height
Pre-tilt positioning:
•
For 0º pre-tilt use hole positioning number (X) on the packer module.
•
For 3º pre-tilt use hole positioning number (Y) on the packer module
•
For 6º pre-tilt use hole positioning number (Z) on the packer module
Seat-to-Floor Height:
Seat-to-floor height is accomplished by using the same hole number on both the front and
rear posts when raising or lowering the seated position.
WARNING
DO NOT Increase the front post height independent from the rear posts when providing
seating pre-tilt. Use only the Pre-tilt positioning holes on the Packer module (Figure 20).
NOTE–
For chairs configured with seat elevator and SPOT Tilt, do not increase the pre-tilt to
greater than 0º.
For chairs configured with SPOT tilt and seat elevator do not increase the seat-to-floor
height greater than 3” from lowest position.
K. SEAT PAN AND BACK SIZE ADJUSTMENTS
Your ASAP II seating system can be adjusted to a wide range of widths and depths to accom-
modate specific user needs. Seating dimensions should only be altered by a trained profes-
sional and may require new seat cushions. Please refer to the QM-710/715HD/720 Service
Manual for more detailed instructions on how to customize the size of your seat.
55
56
57
58
56
57
58
55
1st Hole
2nd Hole
3rd Hole
4th Hole
5th Hole
56
XHole 0°
Rear Post
YHole 3°
ZHole 6°
6th Hole
57
1st Hole
Front
Post
2nd
3rd
4th
5th
6th
A
B
58
XI. DEALER SERVICE AND ADJUSTMENT