Quickie Quickie User Instruction Manual & Warranty - page 19
I X . S e t - u p & A d j u s t m e n t
930575 Rev. A
36
930575 Rev. A
I X . S e t - u p & A d j u s t m e n t
37
X. CROSS BRACE
1. Adjustment
a) Remove the four bolts (A) that attach the cross
brace to the side frames.
b) Move the cross brace to the desired location on
the tabs (B).
c) Replace and tighten the bolts.
NOTE–
Align the bolts through holes in the tabs that
correspond on each side. Re-tighten bolts to 100
in.-lbs. Cross braces have 2" of width growth.
Y. STRUT TUBE ASSEMBLY
NOTE–
Strut Tubes are installed on rigid chairs.
1. Width Adjustment
a) Remove the saddle bolts (A) from each end of
the strut tubes (B) for all strut tubes.
b) Remove hardware (C) from strut tube.
c) Slide the adjustable extension (D) to the
desired width.
d) Replace and tighten the saddle bolts in the
strut tubes.
NOTE–
Strut tubes have 2" width adjustment available.
Size changes may require a larger seat insert
and footplates. Call your authorized Sunrise
supplier for details. Use a torque setting of 100
in.-lbs. when making this adjustment.
Z. FOLDING THE CHAIR
NOTE–
Only chairs with cross brace assembly will fold.
1. Folding/Opening
a) To fold the chair, remove the seat and back.
b) Pull the cross brace strap (A) up.
c) Press the side frames together firmly.
d) To open the chair, extend fingers and apply
even pressure with palm of hand directly on
cross brace until it is fully extended.
e) Replace the seat and back.
f) To avoid pinching, be careful when folding or
unfolding a chair.
V. SOLID BACK AND SEAT INSERT
1. Attaching/Removal
a) Position seat and back on the frame.
b) Position clamps on the seat base and backposts.
c) Insert the quick-release pins (A) through the
mounting holes on both the base and backposts.
d) Remove the seat by reversing the above process.
NOTE–
May be equipped with Jay Fit or Conventional
seating (see instructions from seating Owner‘s
Manual).
W. TILT-IN-SPACE
1. Tilt Adjustment
a) Remove trigger release pin (A).
b) Depress the lock lever handle (B), position to
desired tilt, and release handle.
c) Replace trigger release pin
2. Tilt-in-Space Mechanism Adjustment
a) Rotate the jam nut (A) clockwise.
b) Turn the cable adjuster piece (B) until loose-
ness is removed from cable.
c) Tighten jam nut.
NOTE–
Adjustments to tilt-in-space mechanism are rec-
ommended to be made by authorized Sunrise
suppliers.
Tilt Adjustment
A
B
Tilt-in-Space Mechanism
A
B
Solid Back and Seat
A
B
Strut Tube Assembly
D
A
C
B
A
Cross brace
Strut Tube Assembly
B
A