Quilter ES112 Owner's Manual - Contents:
Contents:
1. Extension Speaker
2. Speaker cable
3. Owner’s Manual
Using Your Extension Speaker
Plug one end of the supplied cable into the input jack on the rear of the
extension speaker and the other end into the 8 ohm speaker output jack of
the amplifier. You should only use speaker cables that are rated for
loudspeaker use. Guitar cables are not suitable for connecting loudspeakers
and may damage the cable.
When used with Quilter combo amplifiers:
To use the extension speaker
in addition to
the internal speaker, plug the
extension speaker cable into the EXT SPEAKER output jack on the rear of the
amplifier.
To use the extension speaker
instead
of the internal speaker, unplug the
internal speaker and plug the extension speaker cable into the INT SPEAKER
output jack.
When used with Quilter head amplifiers:
Plug the first extension speaker into the 8 OHM SPKR output jack on the
amplifier. You may then plug a second extension speaker into the 4 OHM SPKR
output jack.
When used with another brand of amplifier:
If the amplifier has multiple speaker output jacks, plug the extension speaker
into the 8 ohm jack. If the amplifier has a speaker impedance selector switch,
set the switch to 8 ohms.
The speaker should only be used with amplifiers rated for 80 watts RMS or less.
Quilter amplifiers use a speaker protection “watchdog” circuit that ensures
that the speaker does not overheat and fail. This enables safe use of the full
200 watts of output power from a Quilter amp.