Quintum Tenor AS Product manual - page 44
Manual is about: Tenor AS VoIP MultiPath/Gateway
Switch
of
125
3-8
P/N 480-0059-00-00
Chapter 3: Installation/Basic Troubleshooting
Power up the System
Once you have all cables connected properly, you are ready to turn the system on as follows:
1. Plug in the AC power cord adaptor to an AC outlet.
2. Locate the on/off switch on the back of the unit and click the switch to On.
The unit will power up and the LEDs will flash and turn off; the power LED will remain lit. For
information about the LEDs, see
Chapter 2: Hardware Components
.
Once the unit is powered up, you are ready to assign an IP address. See the following section
Change
IP Address
.