Please read and save these instructions 9 p.O.Box 961008 fort worth, tx 76161 (817) 626-5483 fax (817) 626-5540 io177-10/09 the bristol ceiling fan installation instructions the bristol.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. What is covered- except as specified below, the manufacturer of this product warrants it to be free of all defects in workmanship and material. What is not covered by this warranty- 1. A...
Unpack your fan and check the contents. Do not discard the carton. If warranty replacement or repair is ever necessary the fan should be returned in original packaging. Remove all parts and hardware. Do not lay motor housing on its side - because the decorative casing may shift. Check all visible sc...
1. Disconnect the power by removing fuses or turning off circuit breakers. 2. If there is an existing outlet box, ensure it is clearly marked "suitable for fan support". If it is not so marked, it must be replaced with an approved one. 3. Secure the outlet box (or make sure the existing box is secur...
5. Electrical connections fig. 9 fig. 9a fig. 9b fig. 9c remember -turn off the power! 1. Disconnect the power and remove the existing wall plate and switch (fig. 9) 2. Set all knobs on the dual slide wall control in the off position. (fig. 9a) 3. Make wire connections (fig. 9b) and secure with wire...
1. Make sure the wiring is safely inside the outlet box as instructed in step 5 - electrical connections. To install the canopy, partially unscrew the 2 screws in the hanger bracket. Align the slotted holes in the canopy with the screws in hanger bracket. Push up the canopy so the screws slip into t...
1. A ceiling fan is an environmentally smart choice to cool as well as to help warm your home or office. Adjust your hvac thermostat during fan use to save additional energy and money on your air conditioning and heating utility bills. You should see a significant reduction in both your heating and ...
Fan will not start 1. Check that the electricity has been turned on at the circuit breaker which had probably been turned off during installation. 2. Turn off the electricity. Check all connections in the wiring of the fan at the ceiling and make sure it follows the wiring instructions outlined in t...
