Qvis APOHDSDI-VAN User Manual - page 11
© Copyright Qvis ®. All documentation rights reserved.
5
STEP 3
Draw out the cable
’s exit hole and four screw holes upon the installation position according to the device
pedestal. Drill the four plastic expansion bolt and the cable
’s exit holes. Insert the four plastic expansion
bolts into the screw holes.
STEP 4
Adjust the camera pedestal to the correct position and then thread the cable through the cable exit, which
you have just drilled in the ceiling/wall. Line up the four screw holes, in the device pedestal, to the four
plastic expansion bolt holes in the installation position. Put the four self-tapping screws in the device
pedestal and then use the screwdriver to secure the screws in the four plastic expansion bolts firmly.
STEP 5
Adjust the device
’s position and line up the three inner hexagon screws of the device to the three holes of
the installation
’s position. Put the three inner hexagon screws into the screw holes at the bottom of the
pedestal. Use the inner hexagon screwdriver to fix firmly into place. Connect the ground cable to the GND
port to improve stability. See Figure 3-3.
With IR light Without IR light
Figure 3-3
STEP 6
Adjust the X/Y/Z axis of the module to turn the device to the desired monitoring angle. Please follow the
steps listed below to adjust camera correctly. See Figure 3-4.
Please note, for the dome of the IR light, you can skip step
A.
and step
E
.
A. Slightly push in the two sides so you can squeeze the plastic hook to take off the dome enclosure.
B. Manually loosen the screws slightly at the two sides of the X-Y-Z module. You can adjust the
module tilt rotation angle to somewhere between 15
°~
90
°
.