Qvis LX Apollo series Quick User Manual - Part 1: Basic Operations
The LX Apollo series of DVR’s is designed specially for the security and
surveillance field and is an outstanding digital surveillance product.
It has an embedded LINUX operating system which is very stable. It introduces,
as standard, the H.264mp video compression format and the G.711A audio
compression format, which insures a high quality image and low error coding
ratio. Strong network services greatly enhance the network data transmission
capacity and remote control capabilities.
Part 1: Basic Operations
1 Basic Installation
1.1 Hard Disk Installation
Before using your DVR for the first time, please ensure a hard drive is installed.
The number of hard drives (HDD) your DVR can have installed is shown below.
No of HDD
Model
1
LXZEUSL 4-8-16ch, LXZEUSHD 16ch
2
LXZEUSHD 4 Ch, LXAPOHDRT 8-16ch, LXAPOPROLITE
8-16ch, LXAPO32 32Ch
8
LXAPOPRODC 8-16ch
Note: All DVR’s can run and monitor normally without a hard disk, but they
can’t record and playback.
1.2 Mouse Connection
The DVR’s have 2 USB sockets either 1 in the back and 1 in the front panel,
or 2 in the back panel. The 2 USB sockets can be used for the mouse, a flash
stick, a 3G & WIFI module, a movable HDD or a USB DVR-RW.
2 Turning the system on
Plug in the power supply and turn on the power supply switch. If the power
supply indicator light shines then that indicates the video recorder is also on.
When the startup is complete you will hear a beep, and the default setting
screen which is a multiple-window output mode will show.
Note: If you restart the power after an abnormal power turn off, the DVR will
automatically recover to the position it was in before the power went off.