Qwest Actiontec M1000 Troubleshooting Manual - page 5
of
8
© 2008 Qwest Communications International Inc.
11. Select PPPoE.
12. Place a checkmark next to
‘PPP Auto Connect’ if it is not populated
13. Enter the PPP username and password that was provided to you by your Internet Service
Provider (ISP).
Click here
to look up your ISP’s contact information.
14. Complete the next steps according to your ISP
’s instructions, then select Apply. Listed
below are the most common settings.
15.
You will see the ‘Thank You’ screen for a moment.