R.P.S. Corporation GTX Series Operator's Manual - Page 8
PAGE 8
1. Recovery tank lid:
latch must be secured for recovery tank to seal properly.
2. Steering wheel:
steers the machine.
3. Headlight:
helps you see in low light areas and to warn oncoming traffic.
4. Polyurethane rollers:
helps prevent damage to machine and objects you may drive close to.
5. Front drive tire:
(black standard), (grey optional) drives and steers machine.
6. Adjustable seat with arm rests:
your machine is equipped with an adjustable seat with arm rests.
7. Seat adjustment:
permits the seat to be adjusted forward and backward for operator comfort
8. On board charger plug (optional):
plugs into any three pronged outlet to charge machine
9. Side wipers:
controls water on turns by directing it to the squeegee.
10. Horn button:
sounds the horn for warning oncoming traffic.
11. Adjustable steering:
four settings for operator comfort and ease of entry.
12. Machine hour meter:
keeps track of total hours of use on the machine.
13. Battery hour meter:
keeps track of total hours of use on the batteries.
14. Water control lockout:
locks out the solution flow control so it cannot be changed.
15. Down pressure lockout:
locks out the scrub deck down pressure so it cannot be changed.
16. Serial # plate:
machines have individual serial number stamped on it.
17. Foot pedal:
controls the acceleration and deceleration of the machine.
18. Recovery drain hose:
allows for controlled draining of recovery tank dirty water.
19. Spray hose:
(optional) permits cleaning in remote areas.
20. Squeegee/vac hose:
vacuumizes squeegee. Note: keep free and clear of blockage.
21. Rear bumper:
offers squeegee system protection from damage.
22. Squeegee blade:
squeegees water to be recovered by the vacuum hose.
23. Tank latch:
permits access to recovery tank.
24. Tie down points:
location for tie down straps during transport.
25. Squeegee rollers:
help protect the squeegee.
26. Recovery access door:
used for flushing out recovery tank with fresh water.
27. Recovery tank:
holds approximately 35- gallons of dirty "recovery" water.
28. Vacuum screen box:
houses the dual stainless vac screen & shutoff balls.
29. Foam protection screen:
used to protect vacuum motor from debris.
30. Drain saver:
prevents debris from clogging drain.
31. Solution tank:
holds approximately 35-gallons of clean water.
32. Solution tank vent:
prevents vacuum from forming in the tank during operation.
33. Lcd screen:
lists functions and setting of the machine. (see page 9)
34. High water recovery light (red):
indicates when the recovery tank is nearly full.
35. Menu control:
scrolls through different options on the LCD display.
36. Scrub deck down pressure switch:
controls the pressure put on the scrub deck.
37. Scrub deck switch:
raises and lowers the scrub deck.
38. Squeegee switch:
raises and lowers the squeegee.
39. Solution flow control switch:
push down to reduce & up to increase flow.
40. "uni-touch" button:
activates brushes, squeegee, and solution flow simultaneously.
41. Forward/reverse switch (red):
controls the direction of the traction motor.
42. Spray jet (blue):
(optional)
activates spray pump for remote spray wand.
43. Vacuum switch (white):
for use with remote vacuum wand.
44. Econ switch:
45. Key switch:
turns the main power on and off.
46. Circuit breaker:
(15 amp) positive bus bar.
47. Circuit breaker:
(15 amp) negative bus bar.
48. Circuit breaker:
(10 amp) side broom motors.
49. Circuit breaker:
(2 amp) side broom lift actuator.
50. Side broom (yellow):
lifts and lowers side brooms which turn on automatically.
51. Suds switch:
52. Emergency stop:
shuts machine down in a emergency
Controls and Functions
Factory
Cleaning
Equipment,
Inc.
800.793.3790
www.thesweeper.com