RAB Lighting FXLED78 Installation Instructions

FXLED78 INSTALLATION INSTRUCTIONS 

IMPORTANT

READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.

RAB fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper 

grounding is required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE 

INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT 

AND THE HAZARDS INVOLVED.

WARNING: Make certain power is OFF before installing or maintaining fixture. No user serviceable 

parts inside.

Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right.  We’d like to hear your comments.  

Call the Marketing Department at 888-RAB-1000, or email: marketing@rabweb.com

SLIPFITTER MOUNTING

1.  The slipfitter mounting fits a 2 3/8” O.D. 

Tenon. 

Place the slipfitter over the

 Tenon and secure the 

fixture with the 2 

Set Screws on the side of the 

slipfitter.

2.  Remove 2 screws on side of 

Round Cover Plate. 

Remove the 

Round Cover Plate and adjust the 

angle of the fixture.

3.  Loosen the 

Locking Bolt and swivel fixture to  

desired angle.

4.  Tighten the 

Locking Bolt and re-attach  Round 

Cover Plate.

Tenon

Set 

Screws

Round 

Cover 

Plate

Locking 

Bolt

Pivot Bolts

TRUNNION MOUNTING

CAUTION: UL and C-UL listed or CSA certified liquid 

tight cord grip suitable for use with three conductor 

type STW flexible cord shall be used for connection 

to a wet location outlet box provided by others. 

To adjust the angle of the fixture using the trunnion:

1.  Loosen the 

Pivot Bolts & angle locking screw.

2.  Adjust fixture to desired angle.

3.  Tighten 

Pivot Bolts & angle locking screw.

TROUBLESHOOTING  

1.  Check that the line voltage at the fixture is correct.  

Refer to wiring directions. 

2.  Is the fixture grounded properly?

3.  Is the photocell, if used, functioning properly?

WIRING

Universal voltage drivers permits operation at 120V to 

277VAC, 50 or 60 Hz.

1.  Connect the BLACK fixture lead to the  

(+) LINE supply lead. 

2.  Connect the WHITE fixture lead to the 

 (-) COMMON supply lead. 

3.  Connect the bare copper Ground wire from fixture 

to supply ground.