Rabbit Air SPA-780A User Manual - Cleaning and Maintenance
Safety
Instructions
Operating
Instructions
T
roubleshooting
T
ips
C
ustomer
S
ervice
01
02
25
26
CLEANING and MAINTENANCE
FILTER REPLACEMENT
Cleaning the Lens on the Back of the Front Panel
Cleaning the Unit
Use a dry and soft cloth to clean the unit.
●
Remove the front panel from the unit and use
a dry cloth, soft brush, or cotton swab to dust
off the mood light on the back of the panel.
●
Use a wet cloth if necessary but do not use a
polisher.
Use a wet cloth if necessary but do not use
a polisher.
Cleaning the Nano-Silver Pre-Filter
Pull the bottom of the front panel to
remove it from the unit.
❶
Pull the filter out as shown on the
picture at the right.
❷
Run a vacuum cleaner with a nozzle or
brush attachment on low power
setting along the Pre-Filter to pick up
the dust and particles.
❸
Dry the filter completely before attaching
it to the filter case. Load the case onto
the unit again.
❹
Replacing the Medium Filter
(Every 12 Months)
Remove the filter from the filter case.
Do NOT discard the filter holder.
❶
To replace the medium filter, remove the
new filter from the plastic bag, attach it to
the filter holder,and
place it back into
the filter case.
❷
Always unplug the unit before cleaning/replacing the filters.
Depending on the amount of pollutants in your indoor environment, the frequency
of replacing the filter varies.
When placing the filter case back into unit, make sure the bottom of the case goes
into the unit first, and then follows the top.
Replacing the BioGS
™
HEPA Filter
(Every 12 Months)
Remove the front panel and then the
BioGS
™
HEPA filter.
❶
Attach the pre filter to
the filter case by aligning
the filter with the hooks
of the case.