Race Energy BCM21 Installation & user manual - page 11
11
The recommended charging voltage for any type of battery will vary with temperature.
The warmer the battery, the lower the charging voltage required. The three top
LED’s indicate Cold, Warm, Hot and Auto.
Cold, Warm and Hot and correspond
to battery temperatures of 10, 25 or 35
degrees Celsius respectively (50, 77 or 95
Fahrenheit). In Auto, the charger measures
its own internal temperature during startup, and estimates the batteries to be the
same temperature and applies the appropriate compensation (Default).
DEFAULT BATTERY TEMPERATURE
Default Battery Temperature Indicators
POL
BAT
TEMP
AC
COLD
HOT
WARM
Default Battery Temp 10C
BLINKING
Auto Battery Temp
POL
Default Battery Temp 25C
BAT
TEMP
AC
COLD
HOT
WARM
POL
POL
Default Battery Temp 35C
BAT
TEMP
BAT
TEMP
AC
COLD
HOT
WARM
AC
COLD
HOT
WARM
SAVING
EXIT WITHOUT SAVING
FULL RESET
To save the configuration and exit Setup at any point in the process, press and hold
the Program (PRG) button for 3 seconds until you hear a one second beep.
To exit without saving, either press the On/Off button or do nothing. The charger
will exit the configuration mode without changing the stored configuration after 60
seconds elapses without any button being pressed.
To restore the charger to its factory default settings, enter the programming mode
by pressing and holding the PRG button for 3 seconds until you hear a one second
beep and the Charge LED starts blinking. Then press and hold both the PRG and
SEL buttons for 10 seconds until you hear multiple beeps.