Racelogic RLVBDSP02 Instruction Manual - page 4
LED Display
RLVBDSP02_Manual.doc
Revision 1 30/04/2008
Page 4 of 9
Introduction
The RLVBDSP02 is a LED Display module for use with the Racelogic VBOX. It provides an
easy to read display of vehicle speed. In addition to speed the LED display can also show
lateral acceleration, current satellite count and height and vertical velocity. Connection to the
VBOX is via the 5 pin Lemo connector on the VBOX.
The speed figure shown on the display is heavily smoothed when compared with the actual
GPS speed, to allow the user to easily see the vehicle speed when it is changing quickly.
Therefore when you come to a stop suddenly, the display will lag behind the real speed being
measured.
Parts supplied with RLVBDSP02
1 x RLVBDSP02
LED Display
1 x RLVBCAB05
Connection cable to Readout
1 x RLVBACS014
Suction mount for LED Display
Specification
Size - Single
110mm x 50mm x 25mm (4 ¼” x 2” x 1”)
Size - Dual
110mm x 50mm x 30mm (4 ¼” x 2” x 1 ¼”)
Mounting
Velcro mounting suction cups
Weight
Approx 100g / 14.1oz
Display
4 x 7 segment LED. Daylight readable
Speed
Knots or Km/h or Mph
Height
Metres (Ref WGS84) Max 999.9m
Vertical Velocity
M/S
Power
Approx 200mA
Cable supplied
RLVBCAB05