Racelogic RLVBDSP02 Instruction Manual - page 7
LED Display
RLVBDSP02_Manual.doc
Revision 1 30/04/2008
Page 7 of 9
Press the button to cycle through SP0-SP7. When the desired parameter number is
selected, stop pressing the button. After a short delay of approximately 3 seconds the
display will return to operational mode.
Example. To select lateral acceleration press the button in short succession until
the display shows SP 4. After approximately 3 seconds the display will start showing
lateral acceleration (Before Longacc will work, you must have set the GPSLongacc
channel in Extra serial Data under VBOX Setup)
LED Display
Description
Display knots
Display km/h
Display mph
Longitudinal Acceleration
Ensure you have enabled
GPSLongacc in “VBOX Setup” ->” Serial
data” settings
Lateral Acceleration
GPSLatacc in “VBOX Setup” ->” Serial
data” settings
Display number of satellites in view
Display height (Ref WGS84)
Display Vertical Velocity m/s