Rackit MRS-815 Installer/user Manual - page 23
23
CE Notice (European Union)
The symbol indicates compliance of this equipment to the EMC Directive and the
Low Voltage Directive of the European Union. These markings indicate that this sys-
tem meets the following technical standards:
• EN 55022 — “Limits and Methods of Measurement of Radio Interference
Characteristics of Information Technology Equipment.”
• EN 55024 — “Information technology equipment - Immunity characteristics
- Limits and methods of measurement.”
• EN 61000-3-2 — “Electromagnetic compatibility (EMC) - Part 3: Limits -
Section 2: Limits for harmonic current emissions (Equipment input current
up to and including 16 A per phase).”
• EN 61000-3-3 — “Electromagnetic compatibility (EMC) -Part 3: Limits -
Section 3: Limitation of voltage fluctuations and flicker in low-voltage sup-
ply systems for equipment with rated current up to and including 16 A.”
• EN 60950 — “Safety of Information Technology Equipment.”
NOTE: EN 55022 emissions requirements provide for two classifications:
• Class A is for typical commercial areas.
• Class B is for typical domestic areas.
To determine which classification applies to your computer, examine the FCC regis-
tration label located on the back panel of the computer. If the label indicates a Class
A rating, the following warning applies to your computer:
RF INTERFERENCE WARNING: This is a Class A product. In a domestic environ-
ment this product may cause radio frequency (RF) interference, in which case the
user may be required to take adequate measures.
This device is classified for use in a typical Class B domestic environment.
CCC Notice
On Class A systems, the following warning will appear near the regulatory label:
Warning: This is a Class A product. In a domestic environment this product may
cause radio interference, in which case the user may be required to take adequate
measures.