RAD E- ER 700 User Manual - page 15
6.4.
Calibration Software
Standard windows based calibration software is required for the calibration and is
included with every tool.
6.4.1. Installation
To install E-RAD Cal software:
• Place the E-RAD Cal software CD in the CD-Rom drive;
• If installation does not start automatically, select my computer and double
click (open) on the CD-ROM (D) drive. Select and double click the
“setup” file (picture of computer); this will launch the installation
program.
• Software is installed into the folder that is specified by the user and if no
folder is specified this will be automatically saved to C:\Program
Files\New World\ERadCal_V2.
• Once installation is completed, in your start menu there will be shortcut
“New World”. This shortcut will open the E-RAD calibration software.
6.4.2. Uninstalling E-RAD Cal program
If for any reason the calibration software needs to be removed, follow these steps:
• Click on “Start Menu”
• Select “Control Panel”
• Select “Add/Remove Programs”
• Find and select E-RAD Cal in the program list and click on the “Remove”
Button to remove the software from your computer.
6.5.
Calibration Software Operation
Before launching the calibration software, make sure the calibration system is set up
as follows:
• Connect the Serial Cable between the computer and the controller. Use the
supplied Key Span USB to Serial Port adapter provided with the tool if
you are using a computer that has only USB ports and no Serial port
• Turn the Controller on with the hand held gun and communication cable
connected.
On the Computer:
1. In your Start Menu, click on the “New World” tab to open up the
calibration software.
2. The software will automatically search for the Mint Drive. If the system
does not automatically find a Mint Drive, click “search” on the screen in
figure 7 and the program will detect the Mint Drive on the E-RAD.
11