Radial Engineering Shuttle 500 User Manual - page 4
Radial Engineering Ltd.
Shuttle™ 500 Module
True to the Music
®
2
OVERVIEW
The Radial Shuttle is a patch point module that enables you to bring signals in and out of
the Radial Workhorse and other 500 series modules. Think of it as a convenience device. In
other words, it enables you to perform a number of functions via front panel connectors that
otherwise would require rear panel patching or re-routing. Some of the functions the Shuttle
enables include playback routing for overdubbing, direct input from music players or other
audio sources, effects routing and for those with a Workhorse, easier integration of older 500
series modules and rear panel connectivity to a remote patch bay.
Shuttle Used In Older 500 Series Racks
When the Shuttle is used in a non-Radial 500 series rack LOOP-1 is available through the
balanced input and output. LOOP-2 will also deliver an unbalanced signal via the Shuttle
front panel SEND jack.
Balanced
Loop-1
Balanced
Audio Device
Card Slot
XLR Input
Card Slot
XLR Output
Shuttle Used In Radial Workhorse 500 Series Racks
When the Shuttle is used in a Radial Workhorse 500 series rack LOOP-1 is available through
the balanced input and output. LOOP-2 and the Omniport insert are also available and routed
to the Workhorse internal MIX BUSS and mixer section.
Unbalanced
Loop-2
Workhorse
Mixer
Unbalanced
Audio Device
Unbalanced
Audio Device
Balanced
XLR Output
Omniport
Insert Loop
Balanced
Loop-1
Balanced
Audio Device
Card Slot
XLR Input
Card Slot
XLR Output