Radiant EcoSmart ES50LVP Installation, operation and maintenance manual - Safety
3 |
P a g e
SAFETY
INFORMATION
It is the responsibility of the installer to ensure the installation complies with all national and
local building codes and standards, in addition to the instructions outlined in this manual. All
applicable codes take precedence over any instructions made in this document.
This symbol indicates safety alerts. When you see this symbol on labels or in this
manual, be alert to the potential for personal injury. Understand and pay
particular attention to the signal words DANGER, WARNING, or CAUTION.
DANGER indicates an imminently hazardous situation, which if not avoided, will result
in death or serious injury.
WARNING indicates a potentially hazardous situation, which if not avoided, could
result in death or serious injury.
CAUTION indicates a potentially hazardous situation, which if not avoided, may result
in minor or moderate injury. It is also used to alert against unsafe practices and
hazards involving only property damage.
WARNING - Improper installation may create a condition where the operation of
the product could cause personal injury or property damage. Only a qualified
contractor, installer or service agency should install this product. Improper
installation, adjustment, alteration, service or maintenance can cause injury or
property damage. Refer to this manual for assistance.
CAUTION - This product must be installed in strict compliance with the installation
instructions and any applicable local, state, and national codes including, but not
limited to; building, electrical, and mechanical codes.
WARNING - FIRE OR ELECTRICAL HAZARD. Failure to follow the safety warnings
exactly could result in serious injury, death, or property damage. A fire or electrical
hazard may result causing property damage, personal injury or loss of life.
WARNING - Hot water from a boiler used to satisfy heating requirements can be
heated to temperatures of 180°F. Parts containing water this hot can scald very
quickly. Use extreme caution when servicing or performing maintenance on any
parts containing hot water. To avoid severe burns, allow equipment to cool before
performing maintenance.