Radiant P1220 POS User Manual - page 11
P1220 User Guide
Version .9
4/12/05
than North America, special wall outlet adapters or cables will be required. For international configurations of
the P1220, typically the county specific power cord is ordered separately.
Moisture: The P1220 is water-resistant. It can easily withstand water over spray and exposure to mild cleaning
agents without sustaining damage. The P1220 should not be sprayed directly, however, as the force of
pressurized water could potentially compromise the seals around the touch screen, and/or invade the enclosure
through the cooling vents. Accordingly, P1220 units should not be installed in areas where they might be
exposed to direct water spray. P1220 units are not meant for outdoor installation.
Touch Screen Cleaning: Any standard glass cleaner can be used to clean the touchscreen. Always spray the
glass cleaner on the cloth or towel and then clean the touchscreen to prevent cleaner from running down the
glass and gathering on the front bezel.
With Radiant Application Software: Upon the initial boot of the P1220, typically the Back Office server
should detect the new P1220 and send all appropriate data files to the unit. After the initial file transfer has
completed, the unit will automatically reboot. Following the reboot the P1220 unit should be fully operational.
With Third Party Application Software: The P1220 will boot to the operating system or directly to the third
party application.
Wall Mount Installation
The P1220 can be wall mounted using the wall mount bracket below. It includes a bracket that holds the power
brick next to the terminal
Secure wall mounting bracket using 4 ¼-inch screws.
Note: The 2 screws must be centered on a stud when mounting to a sheet rock wall.
Install the power brick bracket by sliding on wall mount bracket and locking it in place.
Place terminal on wall mount bracket by aligning 4 round mounting posts on back of P1220 touch head with 4
keyhole slots on the wall bracket.