Radio Shack 15-303 User Manual - page 6
6
Se
tu
p
3.
On your universal remote, press and hold
SET
, and then press a device key (
TV
,
VCR/DVD
,
SAT/CBL
,
AUX
). The device key lights up and stays lit, indicating that
the remote is in setup mode. Release both buttons.
n
Note
: Do not hold down the keys for longer than 3 seconds or the remote enters
auto search mode.
4.
Enter the first 3-digit code for your device and brand. Pause briefly between each
digit to make sure the remote receives all inputs. The device key flashes when input
is received, then turns off if you entered the right code. If the device key stays lit,
enter the next code for your device and brand.
Repeat for all possible codes until
the device light turns off.
5.
Verify the setup by testing the remote control’s buttons and functions. If some of
your device’s functions do not respond to the remote, repeat step 4 with another
code.
n
Notes
:
• To use a different type of device than what is labeled on the device key, follow the
“
Copying Device Codes
” steps on page 11.
• If you want to quit during device setup, press the device key or wait 10 seconds for
the remote to exit setup automatically.
• If you are uncertain about your 3-digit code entry, follow “
Check Current Brand Code
”
on page 9 to confirm your code.