Radio Shack 2-way portable amplified speaker system Owner's Manual - page 2
Co
nnect
ing Spea
kers
2
2. Place four batteries in each speaker’s compartment, as
indicated by the polarity symbols (+ and –) marked
inside the compartment.
3. Replace the cover.
.#
7
5+0)
"#%"
14
"&%"2
19'4
To power the speakers from an AC outlet or your vehicle’s
battery power, you need an AC or DC adapter and a size M
Adaptaplug
(neither supplied, available at your local
RadioShack store).
1. If necessary, set the adapter’s voltage switch to 12V.
.
2. Attach the Adaptaplug to the adapter’s cord with the tip
set to positive (+).
3. Insert the barrel plug into the speakers’
DC 12V 600mA
jack. This disconnects the internal batteries.
4. Plug the other end of the adapter into the power
source.
%100'%6+0)"52'#-'45
You can connect the amplified speakers to the audio
source’s headphone or line-out jack.
.
1. Make sure
POWER
is set to off (POWER indicator does
not light).
2. Set the audio source’s power switch to off.
3. Plug the amplified speakers’
1
/
8
-inch plug into the audio
source’s head-phone or line-out jack.
.
"%#76+10"
.
•
Always dispose of old batteries
promptly and properly.
•
You must use a (Class
2 for AC) power source
that supplies 12V DC
and delivers at least 600mA. Its
center tip must be set to
positive and its plug must fit the
speakers's DC 12V 600mA
jack. Using an adapter that
does not meet these
specifications could damage the
speakers or the adapter.
•
Always connect the adapter to
the speakers before you plug it
into the power source, and
unplug the adapter from the
power source before you
unplug it from the speakers.
•
To protect your hearing, set
VOLUME to its minimum level.
!
V
V
V
V
(headphone jack) — lets you
connect an optional headphone
so you can listen in privacy.
DC 12V 600mA — lets you connect
an optional AC or DC 12V adapter
to power your speaker system.
±
"016'"
±
"
If the audio source does not have a
1
/
8
-inch jack, you need an adapter
plug (available at your local
RadioShack store).