Radio Shack 2-way portable amplified speaker system Owner's Manual - page 3
Us
ing Y
our S
peaker
s
3
75+0)";174"52'#-'45
1. Press
POWER
. The POWER indicator lights.
2. Turn on the audio source.
3.
If you connected the amplified speakers to an audio
source’s line-out jack,
adjust
VOLUME
to a comfortable
listening level.
If you connected the amplified speakers to an audio
source’s headphone jack,
set the audio source’s
volume control to a mid-level, then adjust
VOLUME
on
the speaker to a comfortable listening level.
4. Adjust
BASS
to enhance or decrease the low frequency
sounds. Adjust
TREBLE
to enhance or decrease the
high frequency sounds.
5. To turn off the speakers, press
POWER
. The POWER
indicator goes off.
%#4'
Keep the speakers dry; if they get wet, wipe them dry
immediately. Use and store the speakers only in normal
temperature environments. Handle the speakers carefully;
do not drop them. Keep the speakers away from dust and
dirt, and wipe them with a damp cloth occasionally to keep
them looking new.
.#
5'48+%'"#0&"4'2#+4
If your speakers are not performing as they should, take
them to your local RadioShack store for assistance.
Modifying or tampering with the speakers’ internal
components can cause a malfunction and might invalidate
their warranty.
52'%+(+%#6+105
Frequency Response ........................................... 100 Hz – 15 kHz
Impedance ........................................................................... 8 ohm
Tone Boost ................................................. Bass
±
8 dB at 100 Hz
Treble
±
8 dB at 10 kHz
Input Sensitivity .................................................................. 350 mV
Power Output (at 10%THD) ............................................... 2 W/CH
Power Requirement ........................................................... 12V DC
8 C batteries (not supplied)
12 Volt AC/DC Adapter (not supplied)
.
"%#76+10"
.
You might permanently damage
your speakers by cleaning them
with a vacuum cleaner. Use a
feather duster or a soft loose cloth
instead.