Radio Shack 3200026 User Manual - page 17
17
O
pe
ra
tio
n
Monitoring a Second Input Source
Monitoring a second input source requires listening to an input source, finding
the desired audio section you want to mix, and adjusting its sound level to
match the volume of the first input source (ASSIGN A).
1. Connect and put on your headphones. You can listen to one source through
the headphones while the other source plays over the sound system.
2. Set ASSIGN B to the second input source.
3. Press CUE for the second input (above the CHANNEL control).
4. Select PHONO 1/LINE 1, LINE 2, PHONO 2/LINE 3, LINE 4, LINE 5, LINE 6,
LINE 7 or USB, depending on the location of the second input source.
5. Play the second input source.
6. Adjust the second input source’s volume to its preset signal level. If using
headphones, adjust the CUE level (headphones volume) to a comfortable
listening level.
7. When you reach the desired section of music to mix, stop or pause the second
input source.
Switching to a Second Input Source
1. Play the second input source.
2. When you are ready to hear it play on your sound system, slide the CROSS
FADER from CH A to CH B.
3. Slide the CROSS FADER to the left (CH A) to fade in ASSIGN A (first input
source) and fade out ASSIGN B (second input source). Slide the CROSS
FADER to the right (CH B) to fade in ASSIGN B and fade out ASSIGN A. Slide
the CROSS FADER to the center to equally mix the two.
n
Note: Do not slide the CROSS FADER to the center when monitoring
a channel while another is playing. Instead, slide the CROSS FADER to the
channel you are not monitoring. For example, to monitor channel 1 (ASSIGN
A) while channel 2 (ASSIGN B) is playing, slide CROSS FADER to CH A.
CROSS FADER
ASSIGN A
ASSIGN B
3200026_UG_EN_041912.indd 17
5/15/2012 10:19:14 AM