Radio Shack 4-Channel Stereo Microphone Mixer Owner's Manual - Limited One Year Warranty

Other manuals for 4-Channel Stereo Microphone Mixer: Owner's Manual

Manual is about: 4-Channel Stereo Microphone Mixer

Page of 12

Download

Print this page

Bookmark us

trademarks used by RadioShack Corporation.

Printed in China

32-2056

06A04

This product is warranted by RadioShack against manufacturing defects in material and workmanship

under normal use for one (1) year from the date of purchase from RadioShack company-owned stores

and authorized RadioShack franchisees and dealers. For complete warranty details and exclusions, check

with your local RadioShack store.

RadioShack Customer Relations

200 Taylor Street, 6th Floor, Fort Worth, TX 76102

04/04

limited one year warranty

speciﬁcations

Input Sensitivity:

Mic ...................................................................................... 1.5 mV/600 ohm

Line ...................................................................................... 150 mV/ 27k ohm

Output Level at 10k Ohm Load .............................................................. 1.2V

Input Overload:

Mic ..................................................................................... more than 250 mV

Line ............................................................................................ more than 6V

Distortion ............................................................................... less than 0.2%

Signal-to-Noise Radio .........................................................better than 60 dB

Frequency Response ................................................. 10 ~ 35,000 Hz ± 3 dB

Power Requirements:

DC ............................................................................................ one 9V battery

AC Adapter ....................................................................DC IN 9VDC, 300 mA

AC OUT 120V AC, 60 Hz

Dimensions (HWD) .................................................. 2

x 10

x 6

inches

(5.5 x 27 x 16 cm)

Weight .............................................................................1 lb 10.5 oz. (850 g)

Speciﬁcations are typical; individual units might vary. Speciﬁcations are

subject to change and improvement without notice.

« ‹ Prev 6 7 8 9 10 11 12

Summary of 4-Channel Stereo Microphone Mixer

Page 1
Please read this user’s guide before installing, setting up and using your new product www.Radioshack.Com mixer user’s guide thank you for purchasing your 4-channel stereo microphone mixer from radioshack. What’s included 32-2056 4-channel stereo microphone mixer your radioshack 4-channel stereo mic...
Page 2: The Basics
2 the basics contents important safety instructions .................... 3 setting up your mixer ................................. 6 installing batteries ...............................................................6 using ac power .....................................................................
Page 3: The Basics
3 the basics important safety instructions read instructions — all safety and operating instructions should be read before the appliance is operated. Retain instructions — the safety and operating instructions should be retained for future reference. Heed warnings — follow all warnings on the applia...
Page 4: The Basics
4 the basics electrician to replace your obsolete outlet. Do not defeat the safety purpose of the polarized plug. Power-cord protection — route power-supply cords so they are not likely to be walked on or pinched by items placed on or against them, paying particular attention to cords at plugs, conv...
Page 5: The Basics
5 the basics * when the power-supply cord or plug is damaged. * if liquid has been spilled or objects have fallen into the appliance. * if the appliance has been exposed to rain or water. * if the appliance does not operate normally by following the operating instructions. Adjust only those controls...
Page 6: The Basics
6 the basics setting up your mixer installing batteries your can power the mixer with a 9-volt battery (not supplied). 1. Remove the battery compartment cover. 2. Insert the battery. 3. Replace the cover. Replace the battery when battery low lights. Using ac power your can power your mixer with a 9v...
Page 7: The Basics
7 the basics presetting the mixer to prevent accidental audio mixing or channel overdrive, adjust the mixer’s controls as shown before you turn on power. A sudden high output from the mixer could damage audio devices connected to the mixer, and could damage your hearing, especially if you use headph...
Page 8: The Basics
8 the basics connections use shielded audio cables (available at radioshack) for all input connections. The connected input source’s signals are routed to the corresponding channel on the mixer. For example, if you connect a cd player to aux 1 l and aux1 r, you will adjust channel 1 and channel 2 to...
Page 9: The Basics
9 the basics four microphones connect up to four microphones to the mixer’s mic jacks (1-4). Each microphone signal is routed to the mixer’s corresponding channel. If you connect an audio device and a microphone so they are output to the same channel, the signals from both devices are mixed and cont...
Page 10: The Basics
10 the basics operation 1. Set power to on to turn on the mixer. To avoid popping sounds, always turn on the mixer before you turn on the ampliﬁer. 2. Turn on the output ampliﬁer and leave its volume set to minimum. 3. Set the audio input source’s volume to minimum. Turn on the source, and set it to...
Page 11: The Basics
11 the basics voice-overs talk into a microphone to mix pre-recorded music or sound from an audio input source with your voice. 1. Before talking, adjust channel (corresponding to the connected audio source) to the desired volume level. 2. As the music plays, talk into the microphone. Adjust the mic...
Page 12: Limited One Year Warranty
©2004. Radioshack corporation. All rights reserved. Radioshack and radioshack.Com are trademarks used by radioshack corporation. Printed in china 32-2056 06a04 this product is warranted by radioshack against manufacturing defects in material and workmanship under normal use for one (1) year from the...