Please read this user’s guide before installing, setting up and using your new product www.Radioshack.Com mixer user’s guide thank you for purchasing your 4-channel stereo microphone mixer from radioshack. What’s included 32-2056 4-channel stereo microphone mixer your radioshack 4-channel stereo mic...
2 the basics contents important safety instructions .................... 3 setting up your mixer ................................. 6 installing batteries ...............................................................6 using ac power .....................................................................
3 the basics important safety instructions read instructions — all safety and operating instructions should be read before the appliance is operated. Retain instructions — the safety and operating instructions should be retained for future reference. Heed warnings — follow all warnings on the applia...
4 the basics electrician to replace your obsolete outlet. Do not defeat the safety purpose of the polarized plug. Power-cord protection — route power-supply cords so they are not likely to be walked on or pinched by items placed on or against them, paying particular attention to cords at plugs, conv...
5 the basics * when the power-supply cord or plug is damaged. * if liquid has been spilled or objects have fallen into the appliance. * if the appliance has been exposed to rain or water. * if the appliance does not operate normally by following the operating instructions. Adjust only those controls...
6 the basics setting up your mixer installing batteries your can power the mixer with a 9-volt battery (not supplied). 1. Remove the battery compartment cover. 2. Insert the battery. 3. Replace the cover. Replace the battery when battery low lights. Using ac power your can power your mixer with a 9v...
7 the basics presetting the mixer to prevent accidental audio mixing or channel overdrive, adjust the mixer’s controls as shown before you turn on power. A sudden high output from the mixer could damage audio devices connected to the mixer, and could damage your hearing, especially if you use headph...
8 the basics connections use shielded audio cables (available at radioshack) for all input connections. The connected input source’s signals are routed to the corresponding channel on the mixer. For example, if you connect a cd player to aux 1 l and aux1 r, you will adjust channel 1 and channel 2 to...
9 the basics four microphones connect up to four microphones to the mixer’s mic jacks (1-4). Each microphone signal is routed to the mixer’s corresponding channel. If you connect an audio device and a microphone so they are output to the same channel, the signals from both devices are mixed and cont...
10 the basics operation 1. Set power to on to turn on the mixer. To avoid popping sounds, always turn on the mixer before you turn on the amplifier. 2. Turn on the output amplifier and leave its volume set to minimum. 3. Set the audio input source’s volume to minimum. Turn on the source, and set it to...
11 the basics voice-overs talk into a microphone to mix pre-recorded music or sound from an audio input source with your voice. 1. Before talking, adjust channel (corresponding to the connected audio source) to the desired volume level. 2. As the music plays, talk into the microphone. Adjust the mic...
©2004. Radioshack corporation. All rights reserved. Radioshack and radioshack.Com are trademarks used by radioshack corporation. Printed in china 32-2056 06a04 this product is warranted by radioshack against manufacturing defects in material and workmanship under normal use for one (1) year from the...