Radio Shack 43-3546 Owner's Manual - Important Information

Manual is about: 2.4 GHz Cordless Telephone with Headset Jack

Summary of 43-3546

  • Page 1

    © 2003 radioshack corporation. All rights reserved. Radioshack and radioshack.Com are trademarks used by radioshack corporation. E nergy s tar and the e nergy s tar certification mark are registered us marks. Owner’s manual please read before using this equipment. Ample talk and standby time — the s...

  • Page 2: Important Safety

    Important safety instructions 2 important safety instructions when using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: 1. Read and understand all instructions. 2. Follow all warn...

  • Page 3

    Important safety instructions 3 points or short out parts that could result in a risk of fire or electric shock. Never spill liquid of any kind on the product. 16. To reduce the risk of electric shock, do not disassemble this product. Take it to a qualified service technician when service or repair ...

  • Page 4: Save These

    4 introduction 5. Charge the battery pack provided or identified for use with this product only in accordance with the instructions and limitations specified in the instruction manual provided for this product. 6. Observe proper polarity orientation between the battery pack and battery charger. Save...

  • Page 5: Recharging The Battery Pack

    Installation 5 1. Plug one end of the supplied modular cord into the tel line jack on the bottom of the base. " " " " 2. Insert the supplied ac adapter’s barrel plug into the dc in 9v jack on the bottom of the base and route the adapter’s cord through the strain relief slot on the base. 3. Route the...

  • Page 6

    Installation 6 • when you first use the phone after charging or recharging the battery pack, the phone might not work and you might hear an error tone. Return the handset to the base for about 3 seconds to change the security access-protection code. • if the battery pack becomes weak during a call, ...

  • Page 7: Using Your Phone

    Using your phone 7 during a call, you may “switch-over” to tone dialing (refer to “tone dialing switch-over”). Using your phone m aking and r eceiving c alls Ô a djusting the r inger t one when the phone is in standby mode, pressing the vol/ring key on the handset selects the handset ringer tone. Th...

  • Page 8

    Using your phone 8 temporarily silenced. The ringer tone will return to normal starting with the next incoming call. T one d ialing s witch - over some telephone companies use equipment that requires pulse dialing (sometimes referred to as rotary dialing). If you need to enter tone dialing digits, y...

  • Page 9: Dialing A Memory Number

    Using your phone 9 telephone numbers. You can store your most frequent dialed number in the one-touch speed dial location. Ô 1. Remove the handset from the base. 2. Press mem . The talk/batt low flashes. 3. Enter the phone number, up to 20 digits. If a pause is needed during the dialing sequence, pr...

  • Page 10

    Using your phone 10 3. Press speed dial or the memory location ( 0 - 9 ). A tone indicates that the stored number is erased from memory. Changing the digital security code the digital security code is an identification code used to connect the handset and the base unit. Normally, setting the code is...

  • Page 11: Troubleshooting

    Troubleshooting 11 troubleshooting if you still have problems, disconnect the phone. If other phones on the same line work properly, the fault is in this phone or its installation. If you cannot find the problem, take the phone to your local radioshack store for assistance. Care keep the phone dry; ...

  • Page 12: Important Information

    43-3546 upzz01010zz 01a03 printed in china radioshack corporation fort worth, texas 76102 important information this telephone has been tested and found to comply with all applicable ul and fcc standards. Fcc statement your telephone compiles with part 68 of the fcc rules.Upon request, you must prov...