Radio Shack 63-1110 - Wireless Mail Guard Owner's Manual - page 7
7
Installation
Replacing Batteries
When the transmitter stops operating properly, re-
place the batteries.
1. Press the latch on the mounting bracket to
release the transmitter.
Caution: Do not pull the transmitter from its
bracket without releasing it from the lever. You
might damage the transmitter, its bracket, or
loosen the tape’s adhesive bond.
2. Follow the Steps under “Installing Batteries” on
Page 5 to replace the batteries.
Warning: Dispose of old batteries promptly and prop-
erly. Do not burn or bury them.
TESTING THE SYSTEM
Before you install your system and permanently
mount any components, test the transmitter and base
(receiver) to determine the best location and set up.
Testing the Channel Selection
1. Place the transmitter in a completely dark closet.
63-1110.fm Page 7 Friday, September 22, 2000 3:33 PM