Radio Shack Audio/Video Signal Sender Owner's Manual
OWNER’S MANUAL
Please read before using this equipment.
www.radioshack.com
SM
Because most DVD players do not have A/V
input jacks, be sure to connect a DVD player last
in the string of components as shown in the
diagram. (A/V Components 1 and 2 could be a
VCR, cable box, or satellite receiver.)
To TVs with Other A/V Components
Antenna
DC 9V
Jack
15-2572
Audio/Video Signal Sender
CONNECTING THE A/V SENDER
To TVs with A/V Jacks
Ô
Note
Ô
• Be sure the Audio/Video cable’s
plug colors correspond with the
sender’s, receiver’s, and TV’s
jack colors. If your TV’s jack
colors do not match the cable’s
colors, connect the yellow plug
to the video jack, the red plug to
the audio R jack, and the white
plug to the audio L jack.
• The antennas do not rotate 360
degrees. Rotating them past the
stopping point may cause
damage.
To TVs Without A/V Jacks
Connect the sender to the desired A/V component using
the A/V cables, and then connect the component to your
TV using the supplied coaxial cable.
Thank you for purchasing a RadioShack Audio/Video Signal Sender. Your A/V Sender let’s you control A/V signals from up to 100 feet away.
You no longer need additional DVD players, VCRs, cable boxes, or satellite receivers to enjoy programming in another room. And the
included IR Extender feature lets you use your existing remote to control your components.
CONNECTING THE RECEIVER
To TVs with Other A/V Components
If your other A/V component (such as a satellite
receiver) is connected to the TV using A/V
cables, you can connect the receiver to the
unused LINE IN jacks on the component.
To TVs with A/V Jacks
DC 9V
Jack
To TVs Without A/V Jacks
Use the supplied coaxial cable to connect the TV
OUT COAX socket on the receiver to the Antenna
input on your TV. If you already have an antenna
connected to your TV, you will also need to use an
A/B switch.
Set your TV and CHANNEL on the receiver to the
same channel (3 or 4).
TV OUT
COAX
CHANNEL
A, B, C, D
1. Connect the other set of Audio/Video
cables to the A/V OUT jacks on your
receiver. Connect the other ends to
your TV.
2. Connect one end of the receiver’s
power supply to the receiver’s DC 9V
jack and the other end to a standard
AC outlet.
3. Position the receiver in a convenient
location (such as on top of your TV)
and orient the antenna so the flat side
points in the direction of the room
where you set up the sender.
FIRST
SECOND
1. Connect one set of audio/
video cables (supplied) to
the sender’s VIDEO IN
and AUDIO IN jacks.
2. Connect the other end of
that cable to the Audio/
Video Out jacks on your
TV.
3. Connect one end of the
sender’s power supply to
the sender’s DC 9V jack
and the other end to a
standard AC outlet.
4. Position the sender in a
convenient location (such
as on top of your TV) and
orient the antenna so the
flat side points in the
direction of the room
where you will set up the
receiver.
TV OUT
COAX
CHANNEL
A, B, C, D
A/B Switch
TV OUT
COAX
CHANNEL
A, B, C, D
TV CHANNEL
3/4
Receiver
Bottom view