Radio Shack Keychain Quick Manual
©
1999 Tandy Corporation.
All Rights Reserved.
RadioShack and Plug ’n Power are registered trademarks used by Tandy Corporation.
Keychain-Remote Control System
Your RadioShack Keychain-Remote
Control System is a valuable accesso-
ry for your Wireless Remote Control
System. With this switch and trans-
ceiver you can individually turn on or
off lights or appliances from any loca-
tion in your home. Using the remote,
you can turn on and off a lamp or ap-
pliance, connected to the transceiver.
You can also turn on and off other
lamps or appliances attached to your
optional Plug 'n Power
®
receivers.
This remote control system is compati-
ble with other Plug 'n Power systems
and controllers, all of which are avail-
able from your local RadioShack
store.
PREPARATION
1. Using a small screwdriver, set the
house code dial of the transceiver
and the dial of the remote (located
inside the remote’s battery com-
partment) to the same letter.
2. Set the slide switch inside the re-
mote's battery compartment to the
unit code of the lamps or applianc-
es you want to control (1 and 2, or
A
E
I
M
E
A
C
I
O
M
K
G
Remote
Transceiver
5 and 6). Set the unit code on each
optional lamp/appliance module to
correspond to the same number set-
ting on the slide switch.
Note: Regardless of the slide switch
setting, the transceiver always turns
on a connected lamp or appliance
using Button 1.
Your appliance switch requires two AAA
batteries (not supplied) for power. For
the best performance and longest life,
we recommend RadioShack alkaline
batteries.
Cautions:
• Use only fresh batteries of the re-
quired size and recommended type.
• Do not mix old and new batteries or
different types of batteries.
Follow these steps to install batteries.
1. Slide the battery compartment cover
in the direction of the arrow to re-
move it.
2. Place the batteries in the compart-
ment as indicated by the polarity
symbols (+ and –) marked inside.
5, 6
1, 2
61-2663.fm Page 1 Wednesday, August 11, 1999 5:05 PM