Radiodetection 1205CXA Operator's Manual - page 27
25
When using the IFD mode, there should be no power
present (RF or AC) that can affect the readings. The
test can take only a few minutes or the instrument can
be left on indefinitely to help capture even the most
stubborn intermittent fault.
4.4 Measuring and Documenting
Measuring - Cable inventory and management can be
very expensive and time consuming. Many companies
have a problem getting technicians to use partial reels
of cable, due to unknown lengths.
While learning to use the TDR, an installation crew
experimented measuring reels of cable. They learned
to measure and use the partial reels, which saved money
and extra trips back to the warehouse.
The TDR can be used to verify the lengths of new reels
of cable or to identify the lengths of unmarked reels of
cable.
Documenting - Contractors can use SUPER-STORE and
WAVE-VIEW to document their work or to use as proof-
of- completion and/or performance. SUPER-STORE can
also be used to show the need for cable replacement
or repair. Documenting a cable section when newly
installed makes a convenient and easy comparison when
problems arise at a later date. Cables can be periodically
monitored for signs of deterioration. SUPER-STORE
and WAVE-VIEW provide a variety of opportunities and
applications not found with any other TDR.
SUPER-STORE
Waveform Storage
is a unique storage
feature of Riser-Bond Instruments’ waveform TDRs.
SUPER-STORE waveform storage, stores all of the
waveform information on screen and off screen. The user
then has the ability to recall and display the waveform at
any time. The waveform can still be fully adjusted. The
only changes that cannot be made are in the pulse width,
the impedance settings, or engaging the filters. This
feature allows a more experienced person to interpret
the waveform, or get a second opinion from coworkers.
It also allows you to do a before and after comparisons,
along with recalling information to test from both ends.
WAVE-VIEW software allows the stored waveforms to be
transferred to a computer where they can be archived,
adjusted, compared, or analyzed. Using WAVE-VIEW
software in combination with the appropriate equipment
allows the user to e-mail stored waveforms.
NOTE: Updates to WAVE-VIEW software can be
downloaded from the Riser-Bond Instruments
website at www.riserbond.com.