RadioLink RC4GS Instruction Manual - page 25
24
Channel selection (SLV)
ST, TH, CH3, CH4
Initial value: ST
Select setup item "SLV" by pressing “Dec(-)” or “Inc(+)” button, press “Enter” button, the initial
slave channel will blink. Use“Dec(-)” or “Inc(+”
) button to select the slave channel you wish to adjust,
press “Enter” button, the blinking slave channel you selected will stop blinking.
(3) Left, forward or up side mixing amount adjustment
Mixing amount
-100~0~+100
Select the setting item "LEFT", "FWRD", or "UP"(These setup items are different depend on the master
channel. ST: "LEFT"; TH: "FWRD"; CH3:"UP") by pressing “Dec(-)” or “Inc(+)” button. Press “Enter”
key, the initial value of "LEFT", "FWRD", or "UP"
will blink, Use“Dec(-)”or“Inc(+)”button to adjust
the left, forward, or up side mixing amount.
(Note: In the interface of adjusting the value, return to the initial value
"0"
by pressin g
“Dec(-)”and
“Inc(+)” buttons simultaneously for about 1 second.)
Press “Enter” key, the adjusted value stops blinking, the selected mixing amount has been adjusted.
(4) Right, brake or down side mixing amount adjustment
Mixing amount
-100~0~+100
Select the setting item "RGHT", "BRAK", or "DOWN"(These setup items are different depend on the master
channel. ST: "RGHT"; TH:"BRAK ";CH3:" DOWN") by pressing“Dec(-)”or“Inc(+)”button. Press “Enter”key,
the initial value of "RGHT", "BRAK", or "DOWN" will blink, Use“Dec(-
)”or“Inc(+)”button to adjust the right, brake, or down side mixing amount.
(Note: In the interface of adjusting the value, return to the initial value "0" by pressing “Dec(-)” and “Inc(+)”
buttons simultaneously for about 1 second.)
Press “Enter” key, the adjusted value stops blinking, the selected mixing amount has been adjusted.
(5) Mixing mode setup
Mixing mode (MXMD)
OFF, MIX
Initial value: OFF
Select setup item"MXMD"by pressing“Dec(-)”or “Inc(+)” button, press “Enter “ button, the initial
mixing mode“OFF”will blink. Press“Dec(-)”or “Inc(+)”button to switch “OFF” to “MIX”, press
“Enter” button, the blinking “MIX” will stop blinking.
"OFF": Mixing proportional to master channel operation.
"MIX": Mixing by master channel another function considered.
(6) When ending setting, return to the initial screen by pressing “Exit” button twice.