RadiSys CE915GM Quick Start Manual - Heatsinks
3
Heatsinks
Table 3
lists the heatsinks offered by RadiSys for use with the CE915GM system.
Table 4
—
Table 6
show a complete list of all the components in the CE‐AHSA, CE‐PHSA, and CE‐PHS17A heatsink
packages.
Table 3. Heatsink product codes
Product code
Description
CE-AHSA
Active heatsink assembly (a fan is built into the heatsink) for any COM Express module in a 2U chassis.
The power connector for the CE-AHSA is ATX-compliant.
Heatsink dimensions: 125 x 95 x 26.90mm
Fan dimensions: 80 x 80 x 15mm
Fan power supply: +5V to +13.8V (+12V recommended)
CE-PHSA
A passive heatsink for any COM Express module in a 1U chassis. A chassis fan is required with this option.
Dimensions: 125 x 95 x 26.90mm
CE-PHS17A
A 17mm low-profile passive heatsink for COM Express modules CE373A or CE738A in a 6HP (ATCA)
blade. An air velocity of 400 lfm [2 m/sec] is required. Use with CE738A requires a chassis fan.
Dimensions: 125 x 95 x 14.94mm
CE-HSPA
Heat spreader for CE760A, solid aluminum, compliant with PICMG COM.0 COM Express specification
Revision 1.0
Dimensions: 125 x 95 x 11mm
CE-TIM
Thermal compound application bar, phase change at 58ºC (136ºF)
Table 4. CE-AHSA heatsink contents
Product code
Description
QTY
Part number
Backer plate
41x36mm, sheet metal (supplied with four M2 flat head
screws)
1
010-02709-00xx
CE-AHSA
Aluminum active heatsink, 125x94x42mm, 12V input
1
019-00352-00xx
Carrier screws
M2.5 x 0.45 x 4 mm, pan head (used to tighten the carrier board
and module)
5
09-0293-00xx
Heatsink screws
M2.5 x 0.45 x16mm, pan head (used to tighten the heatsink and
module)
5
009-01707-00xx
Heatsink spacer
M2.5 clear, 4.5mm outside diameter, 6mm long
1
009-01587-00xx
Module screw
M2.5 x 0.45 x 12 mm, pan head (used with the heatsink spacer) 1
09-0344-00xx
Standoffs
M2.5 x 0.45 x 5mm, hex jam, 4.5 mm outside diameter
5
009-01190-00xx
Washers
2.5mm inside diameter, spring lock (used with heatsink
screws)
5
009-01208-00xx