RadiSys ENDURA TP945GM Quick Start Manual - page 12
12
Quick Start Guide
Connecting font panel devices
The following table gives the pinouts for the front panel I/O header. See
Figure 5,
“Motherboard layout: top view”
on page 5 for the location of this header.
Connecting video devices
The integrated Intel Graphics Media Accelerator (GMA) 950 video controller on the
TP945GM motherboard supports LVDS output at up to 1600 x 1200 32-bit color @
75Hz and RGB analog output at up to 2048 x 1536 32-bit color @ 75Hz. The
motherboard also supports:
PCI Express x16 graphics cards, or Endura Media Expansion Cards
Dual independent displays using any of VGA, LVDS, TV output and Media
Expansion Card interfaces
Composite, S-Video, and Component (YPbPr) TV output
HDTV with 1024 x 768 resolution for NTSL/PAL
Table 1. Front Panel I/O Header
Configuration
PIN#
Pin Name & Description
Hard disk LED
1 & 3
Pin 1: HDD_LED_Power, 5V power for hard disk LED
Pin 3: HDD_LED#, hard disk read/write activity LED
Front panel reset switch 5 & 7
Pin 5: Ground, ground for FP_RESET# pin
Pin 7: FP_RESET#, reset system input
Front panel power
button switch
6 & 8
Pin 6: FP_PWRBTN#, power button input
Pin 8: Ground, ground for FP_PWRBTN# pin
Front panel yellow LED 4 & 2
Pin 2: FP_YELLOW#, yellow LED lights when the system is at S3
(standby) or S4 (hibernate) status
Front panel yellow LED
(ALT)
19 & 15
Pin 15: FP_YELLOW#, yellow LED lights when the system is at S3 or
S4 status
Front panel green LED 2 & 4
Pin 4: FP_GREEN#, green LED lights when the system is at S0
(running) status
Front panel green LED
(ALT)
15 & 19
Pin 19: FP_GREEN#, green LED lights when the system is at S0
status
Front panel speaker
10 & 12/16 Pin 10: 5V, 5V power for speaker
Pin 12: FP_SPKR, speaker
Pin 16: FP_SPKR, speaker
Front panel intruder
18 & 20
Pin 18: FP_INTRUDER#, intruder input (case open)
Pin 20: Ground, ground for FP_INTRUDER# pin
19
20
1
2