RadiSys ENDURA TP945GM Quick Start Manual - page 2
2
Quick Start Guide
Important procedures to note
When installing this motherboard into a chassis or performing upgrades:
Always disconnect the power cord and plug before assembling or upgrading. Parts
on the motherboard can remain powered even when the power supply is switched
off unless the power cord is disconnected.
Route wiring away from sharp edges, heat sources and cooling fans.
Pay attention to the thermal requirements as stated in the sections that follow. This
motherboard requires suitable airflow to maintain an ambient temperature within
the operating range.
When installing expansion cards, pay attention to the maximum loads as stated.
Use UL-approved peripheral cards only.
Align the fansink fins for proper airflow
When installing the fansink onto the TP945GM motherboard, the fansink fins should
point to the rear I/O panel on the opposite side of the board, as shown in
Figure 1
. If
the fins are turned sideways, as shown in
Figure 2
, airflow will be restricted and the
system may not be adequately cooled.
Figure 1. Correct fansink installation
Fins are facing the right direction