RADVision SCOPIA XT4200 Quick Setup Manual - page 2
SCOPIA XT4200
Quick Hardware Setup
CAUTION:
Make sure all units are
switched off whenever connecting
or disconnecting devices.
Package Content:
Codec Unit
SCOPIA XT4200 Camera
1-way Microphone POD
Remote Control Unit and Batteries
Codec Unit Camera Cable
HDMI Cable
1-way Microphone POD cable
Ethernet Cable for LAN, 4m
Power Supply and Power Cable
DVI-I to VGA converter for PCs with VGA output only
XT4200
XT4200 Camera
Make sure to
connect the cable
into the IN connector.
4
15
14
8
5
2
Digital or
Analog
Media
Device
Remote Control
Batteries
Battery model:
CR2025
LITHIUM BATTERY
3V
LITHIUM BATTERY
3V
DC IN 12V
IN RS-232C OUT
DVI
IR SELECT
1 2 3
1 2 3
4
5 6
7
8 9
SYSTEM
SELECT
Layouts
PiP
Inputs
Help
Select
Memo
Far
Near
Presets
9
1
6
7
12
SCOPIA XT4000 series
Codec Unit
Please set the system
selector on the back
of the camera to 7.
16
10
13
11
CAUTION: the mains
cable is used as a
disconnecting device,
use therefore an easily
accessible outlet
located near the
device for the power
supply connection.
Never remove the
mains plug while the
device is connected.
3
RADVISION Optional –
Not Included Accessories
Audio Cable. Both sockets on the unit are dual purpose.
They accept either an analog 3.5mm MiniJack cable
or an optical Toslink cable with a Toslink mini-plug
adapter. Optical digital audio format is S/PDIF. 1-way
microphone POD is connected to the analog/optical
input. Analog/optical output can be used for connection
to analog or digital media device.
Optional microphone POD
DVI to DVI Cable
Non-RADVISION
HDMI Cable for second monitor
Ethernet Cable for LAN2. Second LAN is optional,
and a license key is needed to unlock it.
VGA cable