Rae RAELink3 Quick Reference - Set Unit Id
The RAELink3 enters programming mode:
Network ID: 0001
Change?
To change the Network ID, press [Y/+].
To advance without changing, press [N/-].
To exit Programming Mode, press [MODE].
When changing the Network ID, the cursor flashes on the selected digit:
Network ID: 0001
0001
1. Press [Y/+] to increase the number or [N/-] to decrease the number.
2. Press [MODE] to advance to the next digit.
3. Input a network ID from 1 to 4095 (except 255).
To accept the new Network ID, press and hold [MODE] for 2 seconds.When the
confirmation screen appears, press [Y/+] to save, or press [N/-] to abort the change.
Set Unit ID
Important! Every remote unit in a network must have a unique Unit ID.
Note: When RAELink3 is configured as a Repeater or Host, it does not require a Unit
ID. Some portable monitors require setting of the Unit ID on the monitor. Refer to the
operation manual for the monitor.
With the RAELink3 turned on, press and hold both
[MODE] and [N/-] for 3 seconds. The RAELink3
enters programming mode. Press [N/-] until you see
the screen at right.
Press [Y/+] if you want to change the Unit ID. When changing the Unit ID, the cursor
flashes on the selected digit.
Unit ID: 01
Change?
1. Press [Y/+] to increase the number or [N/-] to decrease the number.
2. Press [MODE] to advance to the next digit.
3. Input a network ID from 00 to 99.
To accept the new Unit ID, press and hold [MODE] for 2 seconds. When the confirmation
screen appears, press [Y/+] to save, or press [N/-] to abort the change
.
RAE Systems, Inc.
3775 N. First St.
San Jose, CA 95134-1708 USA
Toll-free: 888-723-8823
Website: www.raesystems.com
Rev B August 2010 PN: 029-4506-000