Rage Black Marlin BL Instruction Manual - Steering Trim
10
Steering Trim
Steering Trim
The steering trim dial is used to adjust the steering
trim when the wheel is centered.
Rota ng the dial changes the steering trim (the
steering at rest posi on). Normally, the steering trim
is adjusted un l the vehicle tracks straight.
Receiver Connec on and Binding
Binding is the process of programming the receiver to
recognize the GUID (Globally Unique Iden
fi
er) code
of a single speci
fi
c transmi er. When a receiver is
bound to a transmi er, the receiver will only respond
to that speci
fi
c transmi er. If you need to rebind for
any reason, please follow these steps:
1.
With the transmi er switched OFF Insert the
bind cable to bind channel slot.
&Ăŝů^ĂĨĞƵƩŽŶ
ŝŶĚĂďůĞ
ŶƚĞŶŶĂ
2.
Power on the receiver, then turn on the
transmi er with pressing on the bind bu on
within 5 seconds.
BIND BUTTON
3.
Release the bind bu on and wait for about 5
seconds.
4. A er the receiver LED stops
fl
ashing binding is
complete.
5.
Unplug the bind cable and then you are ready
to run.
CAUTION: DO NOT leave the bind cable in the bind
channel plug a er binding
fi
nished, otherwise the
binding program will work automa cally each me
when you power on the receiver.
Failsafe Se ng
The Black Marlin comes with the receiver failsafe set
to NONE. In the event of loss of signal the motor will
stop and the vehicle will dri . If the signal is regained
normal func on will return. If you wish to program
the failsafe to a custom se ng just follow these
simple steps:
1.
With both the transmi er and receiver
powered ON, press the bind bu on on the
receiver for about 3 seconds.
2.
The receiver will enter failsafe se ng menu and
the receiver LED will
fl
ash.
3.
You have about 3 seconds to move the controls
to the posi on that you wish to program into
failsafe.
4. A er the 3 seconds the receiver will save the
se ngs and return to normal mode.
5.
If you wish to reset to a di
ff
erent se ng, simply
repeat above steps.