Rage Black Marlin BL Instruction Manual - How To Operate Your Vehicle
11
How to Operate Your Vehicle
• Thro le
Forward
Reverse
Your boat is equipped with a brushless speed control
with a reverse func on. Pushing the thro le trigger
forward will make the motor run in reverse and back
the vehicle up.
Pull the trigger towards you to make the vehicle go
forward.
The propor onal speed control means the farther you
pull it the faster the vehicle will go.
Release the trigger to stop. Adjust the trim if the
motor does not stop when the trigger is released.
CAUTION
: When using reverse only use a low power
se ng to prevent swamping the boat.
• Steering
Right
>ĞŌ
Rotate the steering wheel clockwise while holding the
trigger to turn right.
Rotate the steering wheel counter-clockwise while
holding the trigger to turn le .
If the steering is not ght enough, increase the travel
volume as described in the following sec on.
Changing the Travel Adjust Se ngs
The travel func on supports precise endpoint
adjustments in each direc on for the steering and
thro le channels.
1.
Hold the trigger in the full brake posi on while
powering on the transmi er. The LED
fl
ashes
rapidly, indica ng the programming mode is
ac ve.
2. Thro le End Point: Hold the trigger in the full
thro le posi on. Turn the TH TRIM to adjust
the full thro le end point.
3.
Brake End Point: Hold the trigger in the full
brake posi on. Turn the TH TRIM to adjust the
full brake end point. Return the trigger to the
center posi on.
4. Le Steering End Point: Hold the steering wheel
in the full le posi on. Turn the ST TRIM to
adjust the le end point.
5.
Right Steering End Point: Hold the steering
wheel in the full right posi on. Turn the ST
TRIM to adjust the right end point. Return the
steering wheel to the center posi on.
6. Power
o
ff
the transmi er to save the travel
adjust se ngs. The minimum Travel is 75%, and
the Maximum travel is 150%. The default travel
se ngs are 125% steering and 100% thro le.
Cau on: The user is cau oned that changes or
modi
fi
ca ons not expressly approved by the party
responsible for compliance could void the user’s
authority to operate the equipment.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protec on against
harmful interference in a residen al installa on. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instruc ons, may cause harmful
interference to radio communica ons. However, there
is no guarantee that interference will not occur in
every situa on.
If this equipment does cause harmful interference
to radio or television recep on, which can be
determined by turning the equipment o
ff
and on, the
user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separa on between the equipment
and receiver.